Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

What is Burnin Testing: Voltage/Temperature

Status
Not open for further replies.
R

raviram80

Member level 3
Member level 3
Joined
Jun 8, 2009
Messages
65
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Activity points
1,750
Hi All,

Can someone share any document about Burnin Testing ?

Can someone tell me during Burnin Test when running a high activity pattern for Burnin

1. What is the voltage kept--- is it high or low?

2. What is the Temperature kept --- is it high or low?

Thanks,

Ravi
 

Burnin is used to test if your circuit works at high temperature and high stress.

Vdd should be high, temperature is also high.

To be specific: if your process runs at 1.8V, burnin voltage may be 3V, and temperature usually is 125C. (normally testsing is done at 85C).

Burnin is basically degrading your circuit at an advanced rate. So you can see defects faster.
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top