Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Post Layout Simulation whit L-edit.

Status
Not open for further replies.
Oveis.Gharan

Oveis.Gharan

Full Member level 4
Full Member level 4
Joined
Oct 21, 2006
Messages
197
Helped
34
Reputation
68
Reaction score
25
Trophy points
1,308
Location
Iran
Activity points
2,503
Hi everybody

I have a problem in post layout simulation.
I extract a system from layout in L-edit to spice netlist. Finally in the extract result, i could not find the inputs and outputs nets of my system. Through a lot of nets , it is not clear which nets are in/out ones which pads are.

Could you guide me?

Thanks in advance.
Alireza
 

By extracted result, do you mean your netlist? The parasitic extracted netlist?
You can easily find the ports in the netlist. Think of it as any spice netlist. The subckt is defined at the top or bottom, and all the ports are labelled in that definition.

If the hierarachy of your layout and schematic do not match, then you might have done a flat layout extraction, in which case, the net names get confusing. But in any case, the i/o ports have the same names as those in the schematic, and you should be able to see them in the subckt definition.
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top