Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Resistive CMFB circuit question - capacitors

Status
Not open for further replies.
F

fcfusion

Full Member level 4
Full Member level 4
Joined
Mar 6, 2010
Messages
203
Helped
43
Reputation
86
Reaction score
24
Trophy points
1,298
Activity points
2,826
Hi everyone

I have a simple question about resisitive CMFB circuits. I often see in literature two capacitors in parallel with the CMFB resistors. What's their function?

Thanks
 

ideal_CMFB_circuit.png I think it's either
  • to speed up the CMFB control after fast changes
  • or it's actually a capacitive CMFB coupling, the resistors providing initial states and preventing unusual potential - just for simulation purpose; not necessary in real silicon.
 
I'm aware of only your first suggestion, especially if it's a continous time circuit.

Two resistors across the output will require a current if the differential output is nonzero, and, in an OTA, they will lower the voltage gain; therefore, they're typically taken as large as possible. The large R, combined with the input capacitance of the commom-mode amplifier (typically a gate capacitance), adds a pole to the CMFB loop. Adding a capacitor across the large R introduces a zero that can be used to prevent instability / have higher ugbw (= speed up). At high frequencies the transfer from circuit outputs to CM amp gate is just a capacitive divider now..

Hope this helps,
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top