Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Connect Nets to Vdd and Gnd Plains in PADS Layout?

Status
Not open for further replies.
gilbertomaldito

gilbertomaldito

Full Member level 3
Full Member level 3
Joined
Aug 21, 2006
Messages
159
Helped
4
Reputation
8
Reaction score
3
Trophy points
1,298
Activity points
2,385
Can anybody teach me the simple way how? I tried the help feature for several times and its not so detailed. Please help me

--andrew
 

Andrew,
Connections to power planes should be fairly automatic unless something is not being done correctly.
Your question is very vague. Could you explain a little more about the problem.

eda
 
This is just one method of many.

Choose a active layer, Click (Drafting toolbar), Click (Copper pour), right click, choose (rectangle), draw the shape, assign the shape to the net, Then (tools) (Pour manager) (Flood).

Under Options (Cntrl-alt-g) you can set up many options for this.
 

edaedaeda and beepstar, than kyou very much.. One last question, does anyone of you knows how to make a mesh ground and vdd pour in PADS? im so sorry, Im a newbie at PADS but I need to fabricate my board ASAP.
 

You can rean more about the Copper Pour parameters in this tutorial:
**broken link removed**

pcbman
 
Set pour outline visible, type (po enter), toggles. Select outline, right click, properties, width (small).
Options (Cntrl-alt-g), grids, hatch (big).
Re-pour.
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top