Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Can you measure voltage or resistance without power?

Status
Not open for further replies.

robertrobert905

Newbie level 4
Newbie level 4
Joined
Mar 21, 2010
Messages
6
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,337
I plan to have an analog potentiometer too be hooked up to a stationary bike and when the bike turns left or right, the potentiometer 's dial is going to change and the output will be sent to a DAQ then to labview on a computer.

My question is do i have to power the potentiometer for the to be able to read the output. also can anyone suggest what resistance of potentiometer i should use for this application? I want a 180 degrees of rotation and I've decided on a conductive plastic one because I read that they are less sensitive to noise and have a long life.

thanks for helping me in advance!
 

robertrobert905
yes, you need a power source to apply some voltage to potentiometer. Edge pins connected to ground and +V, middle pin is your output to measure. Value can be anything from 10K to 500K. For the +V voltage you need to check the input voltage range of you eqipment.
 
robertrobert905 said:
My question is do i have to power the potentiometer for the to be able to read the output. also can anyone suggest what resistance of potentiometer i should use for this application? I want a 180 degrees of rotation ..

You need a supply voltage, say 5V, no "power" means no output voltage, and the DAQ cards read voltage, not resistance ..

Any value between 1kΩ to 10kΩ should be fine ..

IanP
:D
 
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top