Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] TLP generator problem, Help!!!

Status
Not open for further replies.
prcken

prcken

Advanced Member level 1
Advanced Member level 1
Joined
Nov 1, 2006
Messages
419
Helped
41
Reputation
82
Reaction score
38
Trophy points
1,308
Location
Shanghai
Activity points
4,059
Hi all
Please help to check the attached schematic of Transmission line pulse generator and its corresponding waveforms at each node.
S1 is a switch controlled by the voltage pulse “swctl” as shown in the picture, when swctl is 0V, S1 is open (huge resistance), when swctl is 1V, S1 is closed (zero resistance).
I have 2 questions:
Q1: why the coaxial cable cannot be recharged to generate a series of pulses? It should be recharged!
Q2: why the voltage at far end of the coaxial cable drops abruptly from 100V to 0? I cannot see a negative reflected waveform.
Thanks
Kehan
 

i set enough time to charge the cable this time, got the waveforms in the attached.
Co in my cable model is 98pF, Rsource is 10Mohm, so the τ is about 10µ for 10m length cable, i need at least 2.3τ time interval to charge the cable up to 90% of Vsource.
the charging time i set is 13.8µs as you can see in the figure. but why the cable is negatively charged for the second round?
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top