Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

setup 25v dc to 50 dc

Status
Not open for further replies.
saidutt

saidutt

Member level 2
Member level 2
Joined
Dec 4, 2009
Messages
43
Helped
6
Reputation
12
Reaction score
4
Trophy points
1,288
Location
india
Activity points
1,592
hi,
i have to develop an circuit.which takes (25v dc)/ 1 amp of current as input and multiples the the voltage by 2 and make it up to (50v dc)/1 amp of current (it should be variable). so please help me out.
thank you
 

Hi Said,
Sorry, nobody can help you, because its inpossible to make from 25V/1A 50V/1A :-(
Thes should be a "perpetum mobile"...
K.
 

    saidutt

    saidutt

    Points: 2
    Helpful Answer Positive Rating
saidutt said:
have to develop a circuit.which takes (25v dc) /1 amp // and make it up to (50v dc) /1 amp //
Click to expand...
You can only get the same power out of such a circuit (minus inefficiency losses) so 25W input means ca. 20W output, which is 50v x 0,4 amp.
First change de DC into AC with some kind of oscillator , then rectify the AC with a voltage doubler or tripler (capacitors and diodes or a coil and a Fet switch).
Or use a 1:2 transformer and a rectifier to get DC.
You can regulate the output DC by coupling a signal back to your first oscillator (to halt it temporarily) or with a linear regulator in the output circuit.
Find a book about the subject, there are so many.
Good luck, At.
 

    saidutt

    saidutt

    Points: 2
    Helpful Answer Positive Rating
Hi Said,
Sorry, but I dont understand the selected system with a 24V step-down transformer & a voltage doubler to 48V + an LM5118 switcher! If your input is DC, cou can not transform it!
If you makes a switcher/bridge to have some alternating/pulse wave to transformation, you must make it, as best way, at same time with a switcher, as the, from you selected, LM5158! :)
These makes all "needed jobs" for you & from the nominell +25V DC input! So you will have the simplest & good solution.
Refer pls to the datasheet! https://www.national.com/ds/LM/LM5118.pdf]
K.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top