chanchal.chauhan
Full Member level 4
- Joined
- Apr 23, 2009
- Messages
- 216
- Helped
- 5
- Reputation
- 10
- Reaction score
- 1
- Trophy points
- 1,298
- Location
- Hyderabad, India
- Activity points
- 2,539
Dear All,
I have one doubt.
How to make RB3 low & then high?
Here RB3 only an input (MCLR is disabled).
Here my options setting is OPTION=0b10010111; so RB3 is always high if i want to make this pin low i need to work on only OPTION bit ( RBWU & RBPU) to low this pin. But after that is not coming high again. That is my doubt.
Here I am using ADC sensing value to make RB3 high & low but once it is going to low state it is not coming again high state.
Please give your some ideas to solve this issue.
Thanks & Regards
Chanchal
I have one doubt.
How to make RB3 low & then high?
Here RB3 only an input (MCLR is disabled).
Here my options setting is OPTION=0b10010111; so RB3 is always high if i want to make this pin low i need to work on only OPTION bit ( RBWU & RBPU) to low this pin. But after that is not coming high again. That is my doubt.
Here I am using ADC sensing value to make RB3 high & low but once it is going to low state it is not coming again high state.
Please give your some ideas to solve this issue.
Thanks & Regards
Chanchal