Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Not getting results with microcontroller first time

Status
Not open for further replies.
N

Naumanpak

Member level 2
Member level 2
Joined
Nov 19, 2009
Messages
51
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,288
Location
Pakistan
Activity points
1,635
Hi experts once again,

Every time I have a problem, you help me out! thanks for that.

How about another one..

I am not getting output results with microcontroller when I switch on power to the circuit. I have to turn the power on and off several times to get the program working on hardware.

I have tried a differnt controller but in vain.

Any suggestions?



cheers
 

What kind of microcontroller? Can you provide a picture of the setup?

Sometimes the oscillator configuration bit is not set correctly, but it really depends on which microcontroller you have.

Thanks,
Matt
 

    N

    Naumanpak

    Points: 2
    Helpful Answer Positive Rating
please check that the xtal osc is working when you apply power.

another possibility is a problem in RESET signal.
the rsest pin may not be in hi or lo as reqd.

check it and post

srizbf
11thmay2010
 

    N

    Naumanpak

    Points: 2
    Helpful Answer Positive Rating
As told our friends first chek out the crystl frequency and the reset pin, i.e , is the crystal frequency is sufficient to your controller and chek out the hardware connections.......................

some times if the crystal frq. is low then the controller will works slowly, and the ground pin connections are made properly.............


thank you,.....................
 

    N

    Naumanpak

    Points: 2
    Helpful Answer Positive Rating
check if crystal oscillator capacitors are of correct rating.
i had similar problem when i mistakenly used capacitors of different values.
 

    N

    Naumanpak

    Points: 2
    Helpful Answer Positive Rating
Awesome! these were the wrong capacitors in use.

Now the things seem steady.


thanks again all for posting!!
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top