Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hello
1-first draw one circular plate in (0,0,0) point by λ radius.
2-draw 1 cylender that its radius is 5mm*exp(5/6) and center is ( 0,0,-5mm) and height is 5mm and its material is vaccume.
3-draw another cylender that its radius is 5mm and center is ( 0,0,-5mm) and height is 5mm+λ/4.
4-substract circular plate and first cylender.
5-select circular plate and by right clicking set it perfectE boundary condition.
6-select external surface of second cylender and right clicking set it perfectE boundary condition.
7-draw one circular plate in (0,0,-5mm) point by 5mm*exp(5/6) λ radius. and select it and set it to wave port by right clicking ....
8- draw one cilender for redaiation box.
9-set analyzing and run it.
by my freind
4-substract circular plate and first cylender.
i m trying but not able to subtract...can i subtract 2D from 3D...????????????
7-draw one circular plate in (0,0,-5mm) point by 5mm*exp(5/6) λ radius. and select it and set it to wave port by right clicking ....
in this formula (5mm*exp(5/6) λ radius) what will be the radius if λ=375?????????
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
