Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Forcing Ares (Proteus) to do Autorouting on only one side

Status
Not open for further replies.
RollingEEE

RollingEEE

Full Member level 3
Full Member level 3
Joined
Mar 25, 2006
Messages
165
Helped
8
Reputation
16
Reaction score
7
Trophy points
1,298
Location
Bangladesh
Activity points
2,406
ares single layer

Hi,

I am designing PCB with Proteus Ares. The autorouter is by default using double sided pcb layout. I want to make only single sided pcbs. can any one please help me out. I tried to define both horizontal and vertical layers as bottom copper but no use.

I tried everything mentioned here:


but no use.
 

autoroute proteus

In Versions prior to V7.4 you need to set the layer usage on a per strategy basis (unless you have defined your own strategies in ISIS you are likely to only have three; POWER, BUS and SIGNAL).

Version 7.4 is identical except you work through the Design Rule Manager on a net class basis.

Iain.
 

proteus single layer

can you please give description of some specific steps?
 

ares proteus

Select system, then Strategies
Then set all pairs to bottom copper. Usually defaults to 2 layer so really only pair one need changing to bottom copper, both should be blue. If you have specified other strategies such as power, you also need to do the same with that, just select in top left box before changing. Easy!

Added after 1 minutes:

Should have mentioned this is in Ares of course
 

    RollingEEE

    RollingEEE

    Points: 2
    Helpful Answer Positive Rating
proteus one side pcb

Ok, Thanks, I guess it does autoroute in bottom layer only, but if the ics are tightly packed, it does not fail to auto route but uses the top layer instead.
 

proteus 1 layer

Whenever I have tried using autoroute, it has just failed to complete on dense boards, maybe there has been a recent change. I always hand route anyway, so probably would not have noticed this.
 

proteus autoroute

Please help me out fast as I am still unable to draw a single sided PCB on Proteus as I found the software very nice but get badly hurt when found that not supporting single layer PCB.

So please help me out as soon as possible as project date approaching.


Regards
Gaurav Sharma
 

Re: Forcing Ares (Proteus) to do Autorouting on only one sid

Watch this video tutorial

**broken link removed**
 

    V

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top