Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

555 Timer? Input sawtooth 0-8 volts, Output adjustable pulse

Status
Not open for further replies.
G

gmcjetpilot

Newbie level 5
Newbie level 5
Joined
Mar 27, 2010
Messages
10
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
USA
Activity points
1,379
This is what I want to do:

Input: sawtooth from 0-8 volts with freq of 30 Hz to 60 Hz

Output: a pulse when input is at a user set voltage between 1-7 volts.
The pulse output is adjustable voltage (3-9v) and duration (5uS to 2mS)

I'm flexible, it is not super critical. I just need a stable trigger even if it has some delay.

If some one can draw out a circuit I would appreciate it.
The 555 timer seems to be the way to go?

Thanks
 

Re: 555 Timer? Input sawtooth 0-8 volts, Output adjustable p

555 is not that flexible, it has “fixed” thresholds and the output pulse is more the less the same as the supply voltage ..
However, you can do almost all what you’ve described with PICAXE-08 ..
Have a look at the attached picture .. it’s self-explanatory ..
P1 can be programmed to “read” the amplitude of the incoming signal, whereas P2 can be programmed to control the width of the output pulse ..
If you vary [V+], that’s the voltage that supplies the output driver, you can vary the “height” of the output pulse ..

Rgds,
IanP
:D
 
Re: 555 Timer? Input sawtooth 0-8 volts, Output adjustable p

IanP said:
555 is not that flexible, it has “fixed” thresholds and the output pulse is more the less the same as the supply voltage ..
However, you can do almost all what you’ve described with PICAXE-08 ..
Have a look at the attached picture .. it’s self-explanatory ..
P1 can be programmed to “read” the amplitude of the incoming signal, whereas P2 can be programmed to control the width of the output pulse ..
If you vary [V+], that’s the voltage that supplies the output driver, you can vary the “height” of the output pulse .. Rgds,
IanP :D
Click to expand...

Hey I was not familiar with the PICAXE-08.... I guess it is a micro controller. Very Cool.... I looked into it a little and it would be fun to learn. Thanks
 

Re: 555 Timer? Input sawtooth 0-8 volts, Output adjustable p

One way doing it with common parts will use a window comparator (2), 2 gates, D type FF and some R&C's

MCU is the more elegant solution
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top