Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

why is SFDR larger than SNR in a properly designed ADC ?

Status
Not open for further replies.

henrywent

Member level 5
Member level 5
Joined
Dec 29, 2008
Messages
83
Helped
5
Reputation
10
Reaction score
5
Trophy points
1,288
Location
china
Activity points
1,869
hi there,
I found that the SFDR of ADC is larger , if not always, than SNR in the datasheet of commercially available ADCs or from my simulations. Is there a definite relation between these two parameters of ADCs ? why is SFDR larger?
Any comment is welcome!
regards,
henry
 

The SFDR is the ratio between the power of the fundamental and the power of the highest tone (harmonic or not) generated by the ADC. The SNR is the ratio between the power of the signal and the power of all the noise (excluding harmonics). So, unless the ADC has an extremely strong tone the SFDR is going to be larger than the SNR.
 
  • Like
Reactions: shanmei

    henrywent

    Points: 2
    Helpful Answer Positive Rating

    shanmei

    Points: 2
    Helpful Answer Positive Rating
So they are totally unrelated to each other ,right ?
 

SFDR and SNR really aren't related much. SNR has to do with the signal
energy versus quantization noise. Some ADCs are noisier than others so they
have an effective number of bits that is less than the actual number of bits
per sample to represent that the noise is higher than what one would expect
for just quantization, e.g. an 8 bit ADC may only have 7.2 ENOB. The SNR
then should be given by ENOB*6 or 43.2 in this case.
 

fubsyman said:
SNR has to do with the signal energy versus quantization noise.
Not only the quantization noise but all the noise sources in the ADC, e.g. mismatch, clock jitter, and so on...
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top