Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi friends,
The first time simulate load pull,a question about the DC block and DC feed components as attached photo,whether i need modify the cap. and RF choke values if i use another device and different frequencics simulated.Or i insert the device into the example directly(why?)?
Thanks,
Don't modify these values, it's acting as a bias tee. You can measure different devices in different frequency band with the same bias tee.
The simulation result is not depending on these values.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.