Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

PCB with edge pin connector- help needed

Status
Not open for further replies.
D

dumarjo

Newbie level 4
Newbie level 4
Joined
Feb 14, 2005
Messages
7
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,321
edge pin in allegro

Hi all,

I need to do a new PCB with edge pin connector. I would like to know how to do this (or document that help me doing it)

I need to do somthing like this.

**broken link removed**

i'm using allegro 16.2. I have no idea hot to create that padstack.

Jonathan
 

edge pin in allegro

If they do have an annular ring at top and buttom, then no sweat.

First dothe pcb and put the pads at the edge of the board, the write in documentasion that drill holes are to done BEFORE millering, then dran a miller line around Your board but keep areas free for "mouse bites" or clearly specify that mounting house is to miller (or laser cut) out the board.

Added after 58 seconds:

adding, do some large connectings at all layers where place permits it.
 

    D

    dumarjo

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top