Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

circular-to-rectangular waveguide transition

Status
Not open for further replies.
mauloftin

mauloftin

Full Member level 6
Full Member level 6
Joined
Oct 29, 2008
Messages
355
Helped
62
Reputation
122
Reaction score
36
Trophy points
1,308
Location
CZ
Activity points
3,285
circular to rectangular waveguide transitions

Hi,

do you know, what the best design for circular-to-rectangular waveguide transition? - circular diameter: 18 mm, rectangular: R120 - 19.05x9.525 - 10.7 - 11.7 GHz. I can do transition with S11 < -20 dB, but I need about -30 dB

Can you help me ?

Thank
 

circular waveguide rectangular transition

Hi mauloftin, I have done some circular to rectangular waveguide transitions. The usual way to go about it is to make some intermediate sections that have the shape of a hexangon. Usually three sections should do the trick, maybe even two. Then vary the lengths of each section and the length of the hexagon sides. Don't use a symmetric hexagon because this will limit the degrees of freedom you have to vary your design. Basically just take a cube and miter the edges, then vary the lengths of the miter and sides of the cube(or rectangle).

good luck
 

    mauloftin

    mauloftin

    Points: 2
    Helpful Answer Positive Rating
circular to rectangular waveguide transition

Thanks, I will try it.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top