Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How the voltage ratio varies with frequency for an air core transformer?

Status
Not open for further replies.
usernam

usernam

Full Member level 5
Full Member level 5
Joined
Mar 9, 2004
Messages
268
Helped
18
Reputation
36
Reaction score
2
Trophy points
1,298
Activity points
2,081
Hi,
I need to know how the voltage ratio between primary and secondary varies with frequency for an air core transformer. What I have noticed with a transformer I'm using is that at 1 Mhz the voltage ratio is 2:1 but at 2 MHz the ratio comes to around 3.3:1.
Can anybody explain this phenomenon please.
 

coupling factor air core transformer

if your examination wherenot in no load conditionincreasing frequency add impedance of transformer and decraeses voltage drop in leakage impedance of both side and resistor impedance but i am not sure
 

air core transformer design

What is happening is you are approaching the natural resonant frequency of the transformer. All coils have some small amount of parasitic capacitance to ground, which forms a resonant tank. If you continue to increase the input frequency, you'll find that the output peaks at some point and then rolls off above that frequency. The peak point is the resonant frequency of the system.
If your function generator only goes up to 2MHz, you can verify this by simply connecting more capacitance across the secondary of the transformer, say 500 or 1000pF, then run another frequency sweep. You'll find the resonant freq has decreased proportional to the increase in capacitance.
 

    usernam

    usernam

    Points: 2
    Helpful Answer Positive Rating
air core toroid transformer

Hi,
Thanks for the reply. I believe thats what is happening. I tested it as you said and it resonated at a lower frequency.
BTW, what is approximately the best coupling factor I can achieve with a solenoid air core & with a toroid air core?
And is there a book or something I can refer to for air core transformer design basics?

Thnx
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top