Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

What is config view in cadence virtuoso environment?

Status
Not open for further replies.
H

henrywent

Member level 5
Member level 5
Joined
Dec 29, 2008
Messages
83
Helped
5
Reputation
10
Reaction score
5
Trophy points
1,288
Location
china
Activity points
1,869
cadence config view

hi there,
what is config view in cadence virtuoso environment and the difference between schematic view, thanks!
regards,
henry
 

config view

a config view is used to select different views (like schematic, verilog-a, verilog, extracted, ...) of a cell in a schematic and enables you to run simulations for that particular configuration.
It is very useful in the early phase of a design: you start with ideal blocks and as you create the schematics for the sub-blocks you can see the effect of the real blocks compared to the ideal ones.
In the later phase of a design you can substitute the schematics with the extracted views and again see the effect.
 
  • Like
Reactions: xinhuaxu

    X

    xinhuaxu

    Points: 2
    Helpful Answer Positive Rating
    V

    Points: 2
    Helpful Answer Positive Rating
    S

    simon_wishes

    Points: 2
    Helpful Answer Positive Rating
config view

its good for doing postlayout simulation to compare result of schematic and extracted view. you can add two instances of the same symbol, one corresponding to schematic view and one to extracted view.
 

    H

    henrywent

    Points: 2
    Helpful Answer Positive Rating
    V

    Points: 2
    Helpful Answer Positive Rating
Re: config view

so it is just a configuration of different views, but not a real view, right? correct me if i am wrong, thanks!
 

config view

to the best of my knowledge, yes. refer to the documentation on cadence hierarchy editor for more information.
 

    H

    henrywent

    Points: 2
    Helpful Answer Positive Rating
config view

yes, it is just a view configuration file not a different view.
 

    H

    henrywent

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top