Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to improve my amplifier's IM3

Status
Not open for further replies.
B

Boowei

Member level 1
Member level 1
Joined
Dec 20, 2006
Messages
37
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Location
China
Activity points
1,522
how to improve an amplifier

I design a amplifier
f:(30-400)MHz
Pout:>25W(CW) @IM3<-25dBc
The circuit and picture as following:
the Mosfets are two MRF9045.
the amplifier's IM3=-26dBc@270Mhz@25W(CW)
but the amplifier's IM3=-18dBc@400Mhz@25W(CW)
How can I improve the IM3?
thanks.


 

im3 amplifier

I think you might want to improve its P1dB. For my experience on this device, if you get P1dB of 50W, then you can reach -30dbc for IM3. Also I suggest to change the IdQ to see what will happen.
 

amplifier im3

For a so wide band application, it's not easy to add predistortion. I think you might want OBO to reach your goal.
 

Hi chaoFan
what is OBO?
Thanks.

Added after 3 minutes:

Hi kspalla
Which pre-distortion circuit is suitable for my amplifier?
May you give me a circuit?
Thanks.

Added after 31 seconds:

Hi kspalla
Which pre-distortion circuit is suitable for my amplifier?
May you give me a circuit?
Thanks.
 

OBO=Output power Back Off
 

    B

    Boowei

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top