Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

out of phase lumped port HFSS

Status
Not open for further replies.
L

lostmymind

Newbie level 6
Newbie level 6
Joined
Mar 31, 2009
Messages
11
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,283
Activity points
1,353
lumped port hfss phase

Hi everybody,


I am currently working on a project in HFSS and I would like to simulate two different antennas both excited by a lumped port one with a phase difference of 180° from the other.But I can't find out how to change the phase of a Lumped port....

I have to use lumped ports because I am dealing with dipole antennas.

Can someone give me a clue of how to proceed with that?

Thanks!:D
 

hfss difference phase port

go to HFSS > Fields > Edit sources....

Then put the amplitude and phase of the excitation.
 
port phase in hfss

Hi shameemkabir,

Thanks for the tip, but I have already tried that, and it appears that the field "phase" is locked in the dialog box "Edit source".

I cannot change the value wich is 0° by default
 

hfss port phase

lostmymind said:
it appears that the field "phase" is locked in the dialog box "Edit source".
I cannot change the value wich is 0° by default
Click to expand...
Hi:

You should put your desired phase under the "Offset Phase" column. and set your unit under the "Unit" column.

Good luck
 

you should change the column "Scaling factor" and "Offset phase". Changing the offset phase to 0 and 180 degree works for me (scaling factor is 1 for both cases).
 
Thanks a lot guys!

I haven't noticed this obvious column!

It works now.


Take Care and Thanks again!
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top