Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

AWR Microwave Office problem with adding a load pull measurements

Status
Not open for further replies.

wakuhuaco

Junior Member level 2
Junior Member level 2
Joined
Mar 31, 2008
Messages
21
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,283
Activity points
1,428
I have a problem with the use of the load pull, when I want to add a measurement, the following error occurs:
"Project contains no valid load pull measurements"
I upload the project in case you want to see



Thx!!!
 

pgain mwo

Hello wakuhuaco,

Yes, you need to have couple of valid measurements to do Loadpull Simulations in MWO...Go through the examples on Loadpull simulations...
Atleast any one of the measurement is required before running the Loadpull Wizard on rectnagular or tabular graph plot...
Total Power: PT
Power Gain at Fundamental: PGain
Power Added Efficiency: PAE

I have modified your MWO project file & it is now running fine...


---manju---
 
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top