Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Please tell about this circut

Status
Not open for further replies.
V

vicky.pace

Member level 1
Member level 1
Joined
May 5, 2008
Messages
36
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,537
Dear All,

Please see attached file and tell me what is the work of Q1 and Q2 in this circuit.
Many times I made smps designs but never seen this cofiguration in opto bias.
Please tell me what is need of this circuit in SMPS.

Thanks
 

Q1, Q2 form a constant current source that gives VBE/R2≈10mA current to the opto LED.
Depending on the output voltage:
- when it is too low, the LED in opto will be off;
- when too high, the LED is biased at 10mA.
I think instead of using PWM to control voltage, here the circuit is activated/de-activated, depending if the output voltage is too low or too high.

The TL431 programable zener is used as reference at 2.5V(1+R4/R5)=13.86V.
 

    V

    vicky.pace

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top