Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Allegro Design Entry CIS 16

Status
Not open for further replies.
Hai ranjith_r,


I also faced like this problems when i starting working on Allegro, you are given all your paramenter setting except LIB.

The footprint name of yours is RES0402, So your should have a 0402 lib with the same name. Check are you configered your lib with that footprint.

--------
For better performance, for each porject keep a seperate LIB.

then configure that lib to that PCB job.
Make sure your all PAD and PSM Paths should be in the same LIB folder.



Thanks & Best regards,
R. Balasubramaniaraju
 

    R

    ranjith_r

    Points: 2
    Helpful Answer Positive Rating
Dear Bala,


Thank you for the information.
Since i am new to this tool , some facts are not clear !
But could you please help me in configuring to footprint and PCB.
What is the PAD and PSM Paths.




Thanking you
Ranjithr
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top