Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

A Question About Delta-Sigma Modulators

Status
Not open for further replies.
N

naalald

Full Member level 4
Full Member level 4
Joined
Dec 2, 2006
Messages
216
Helped
30
Reputation
54
Reaction score
5
Trophy points
1,298
Activity points
2,627
Hi,
When designing DSMs in simulink, if you don't put limitations for the integrators outputs, they may vary much more than ±Vref. But when you put limitations for the integrators outputs, you should correct the filter coefficients to avoid saturation. How can we do this to obtain the optimum coefficients?
Thanks.
 

hi naalald,

my suggestion is that not limit the output of integrator, input the fullscale sine wave for a period of time and record the distribution of integrator's output. set the integrator gain to scale the output within the swing of integrator based on the ratio of the maximum integrator's output to reference voltage. repeat the process and round the integrator gain to a realizable value.
 

    N

    naalald

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top