Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Digital thermometer with 90s2313 and DS1820

Status
Not open for further replies.
P

pasicr

Advanced Member level 1
Advanced Member level 1
Joined
Aug 13, 2005
Messages
440
Helped
39
Reputation
80
Reaction score
29
Trophy points
1,308
Location
Macedonia
Visit site
Activity points
4,213
Hi for all,
I made this thermometer (sch is attached), work fine with 13mm common anode display,
question is:
I need to use Hi-Red 60mm CA 7-Segment LED Display,
is enough only to use +V = 12 V on switching transistors emiters (Q1 to Q4), and replace them with some superior transistor,
regards
 

no my freind , its not enough
also my english is poor

if you connect emiter to +12 your transistors always be on.
you must add 4 zener in base of transistors. same it
**broken link removed**

and now you have other problem:
your led's catods was always negative than anods( +5V < +12 ). so you have little light on all leds.
you must use 8 transistor as open collector on catods , or an open collector chip.
 

    P

    pasicr

    Points: 2
    Helpful Answer Positive Rating
This is another solution.....i have used two transitors instead of one.....as high logic from the mcu cannot cuttoff the PNP transitor because transitor biasing conditions are not fullfilled ....so one possoibilty is that to drive this transistor from NPN ...and give logic from the MCU to base of NPN....see diagram
 

    P

    pasicr

    Points: 2
    Helpful Answer Positive Rating
    V

    Points: 2
    Helpful Answer Positive Rating
I tried your solution for a common anode seven segment, but the first result was a pcb fill of fog, the NPN transistor burn, so I put a 1K resistor, and Bingo is working.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top