Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

impedance matching. Antenna simulation

Status
Not open for further replies.
G

GVVIN

Advanced Member level 4
Full Member level 1
Joined
Apr 11, 2008
Messages
110
Helped
21
Reputation
42
Reaction score
3
Trophy points
1,298
Activity points
2,048
impedance matching antenna

I need to match my antenna to an impedance of 48 - j 148 ohms. (microchip impedance). So the conjugate of that should be my antenna impedance. How to measure this ? Usually we have 50 ohm system and we use a 50 ohm port .

Can we use a 48 ohm port in series with around 1 PF capacitor (which has an impedance of approx -j150 ohms @950 MHz) and then connect my antenna for measurement. Is there any other technique . I am using CST for my simulations.

Thanks
GV
 

matching antenna

Is their any provision in your design for using LC circuits to transfer the impedance to 50ohm. This will solve your most of the problem. If not let me know .
Thanks,
 

rf antenna impedance matching technique

Hi

Your impedance of 48-j148 ohms can be measured with a normal 50 ohm system. Normally you look at the center of the Smith chart(50 ohm), but now your match-"point" is just at another place(48+j148). It is the same matching technique as before and the same when you measure it.

Regards
 

matching

thank you for your replies.

I am trying to design a UHF RFID Tag Antenna. The micro chip impedance is 48-j148 ohms. I cannot use LC matching in actual situation. for simulation I can.

Yes matching can be done but how to define a port, If I am using a loop antenna , I tried to represent the tag impedance using a series resistor and a capacitor and match the antenna to it . I couldnt find any complex port also in CST.

Hope I have explained my concern clearly

Thanks in advance
GV
 

antenna impedence matching with lc

You can easily simulate ports with impedance having reactive parts on HFSS or ansoft designer. Try to use Ansoft designer(Studet version free) Easy to handle for UHF Rfid tag simulation.
 

impedence matching in antenna

You can match complex impedance also with transmission lines instead of use LC circuits
 
ansoft designer impedance matching

Explanation attached
 
lc matching for antenna

GVVIN said:
Explanation attached
Click to expand...

What about the pattern u used on tag antenna??? if you modify the pattern on a simulation tool i have described before(transmission lines acts as capacitor, resistor or inductor), you ll not be on need of capacitor or resistor. So try to use ansoft designer(SV) draw your antenna pattern and use gap source. you can see whatever parameter u need with reports(S, VSWR, impedance etc.)

Good luck. :)
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top