Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to test how fully is a battery charged?

Status
Not open for further replies.
S

ssankurathri

Full Member level 3
Full Member level 3
Joined
Mar 16, 2006
Messages
186
Helped
14
Reputation
28
Reaction score
5
Trophy points
1,298
Location
Bangalore
Visit site
Activity points
2,401
hi
i have a 9v battery. i would like to test it whether it is fully charged or not...
when i use multimeter, i can see it saying 9v. on the battery the current rating is given as 180mAmph.
what this 180mAamph means? how can i know whether it is generating enough current? i mean is there any way to measure the current?

regards
skr
 

Re: testing battery.....

ssankurathri said:
hi
i have a 9v battery. i would like to test it whether it is fully charged or not...
when i use multimeter, i can see it saying 9v. on the battery the current rating is given as 180mAmph.
what this 180mAamph means? how can i know whether it is generating enough current? i mean is there any way to measure the current?

regards
skr
Click to expand...

You can't measure the charge on a battery directly. Your phone/ipod etc, have systems which measure current-in and current-out thus giving an approximaion of how 'full' the battery is.
180mAmph, will be 180mA-h which is milliampere hours, it is a measure of the batteries charge capacity, 180mAh will supply 180mA for 1 hour.

A battery is a voltage source, and not a current source and V=IR will determine the current (the battery will have an upper limit to what current it can supply though)
 
testing battery.....

you connect a 100ohm resistor across your battery..
it will discharge.
and connect current meter in series and connect a voltmeter in parrallel.. initially you will see a 90mA current and 9V...
and as per spec within 2 hours your battery will discharge and voltage will be near 7V..

This is very crude and primitive method...



other wise u have to use constant current sink.. some other similar stuff..
 

Re: testing battery.....

180mA mean that rate of charge is being discharging for 1 hour by load is 180mA. If you want to discharge exacly the chrge on batery in 1 hour you have to use current sink circuit whitch is independent of the voltage of battery
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top