Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

i need help in measuring the settling time

Status
Not open for further replies.
W

wael_wael

Full Member level 4
Full Member level 4
Joined
Dec 3, 2005
Messages
221
Helped
5
Reputation
10
Reaction score
2
Trophy points
1,298
Activity points
2,760
hi guys
could some one of our friends here explain how to do settling time measurement of fully differential amplifier (better if the circuit illustrated in figure), how to make the step unit signal as differential input
i used this circuit below to measure the settling time, but there is a problem that is the input amplitude is effected by VCM not by clock signal amplitude and the out put signals not equal in amplitude and in settling time.

regards
 

yes sure, how to do simulation of fully differential OTA
thank u
 

pls help me in this matter, i have used one configuration but i am not sure about result, could some one send me circuit configuration to find the settling time for differential output
regards
 
Hello,
it is not a clear figure, but is the clock signal differential as from what i see it is CM
 

yes the clock signal is differential, the problem the out put is not equal in amplitude and settling time. is it the problem come from the configuration or form the input signal
63 persons have seen this topic and no body has solution, what happened guys
regards
 

i feel the structure of simulation is right, but i do not understand your problem.
 

Hello,
again are u sure that the clock is working as differential signal in that configuration, i think in the shown schematic it is connected as Common mode
 

    W

    wael_wael

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top