Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

VCO tuning range between 80-90%

Status
Not open for further replies.

AdvaRes

Advanced Member level 4
Advanced Member level 4
Joined
Feb 14, 2008
Messages
1,163
Helped
113
Reputation
220
Reaction score
51
Trophy points
1,328
Location
At home
Activity points
7,442
Hi members,

I noticed that always the VCO tuning range is between 40 and 80 % of the nominal voltage.
What about VCOs in which the Tuning range is between 80 % and 90 % ?
 

VCO tuning range

the tuning range of the VCO depends on the CV curve of the varactor , so to get high tuning range u need the vacattor to have wide tuning volateg

khouly
 

    AdvaRes

    Points: 2
    Helpful Answer Positive Rating
Re: VCO tuning range

You could do this with the control voltage of VCO in the related range.
 

    AdvaRes

    Points: 2
    Helpful Answer Positive Rating
Re: VCO tuning range

AdvaRes said:
Hi members,

I noticed that always the VCO tuning range is between 40 and 80 % of the nominal voltage.
What about VCOs in which the Tuning range is between 80 % and 90 % ?

It is up to the CP output voltage range.
When the Vtune larger than 80% or lower than 20%, CP will be mismatch.
But if you use ADPLL, there is no problem.
 

Re: VCO tuning range

If the VCO could use only 10% of the supply as voltage tuning range it will be more sensitive to noise and tolerances. Typical designs try to maximize the range ro 20-80% which could be covered by either a chargepump or an opamp in an active loop filter.
 

    AdvaRes

    Points: 2
    Helpful Answer Positive Rating
Re: VCO tuning range

As mentioned, if VCO tuning range is covered by 10% of supply then Kvco is very high, making it very sensitive to noise in the tuning voltage.

One designs for a tuning voltage between 20% to 80% of supply rail because that's about the max useful output range of the CP.

This way one can lower the Kvco and reduce sensitivity to noise in the tuning control line.
 

    AdvaRes

    Points: 2
    Helpful Answer Positive Rating
VCO tuning range

Hi

Tuning range is depended on varactor network. You can have a tuning range from 2% to 100%.
 

    AdvaRes

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top