Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Image Rejection Ratio in ADS

Status
Not open for further replies.
Y

ydvkaushal

Newbie level 6
Newbie level 6
Joined
Mar 6, 2008
Messages
11
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,345
image rejection ratio

For any system level design, at which point we have to calculate the image rejection ratio?

Is that at the final output i.e., after Amplifire or can calculate after any subsystem?
 

image rejection ration

Image rejection ratio is the power ratio of image signal before down-convertion (RF) and after down-convertion (IF). So you should calculate the IMRR at the mixer output. But if polyphase filter is used for image rejection, calculate the IMRR at the polyphase filter output.
 

    Y

    ydvkaushal

    Points: 2
    Helpful Answer Positive Rating
how to test image rejection ratio

ydvkaushal said:
For any system level design, at which point we have to calculate the image rejection ratio?

Is that at the final output i.e., after Amplifire or can calculate after any subsystem?
Click to expand...

After the filter usually. which is the most important component for rejection.

So I think you can test it after the system.
 

    Y

    ydvkaushal

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top