deepavlsi
Newbie level 6
Code to find GCD...
I want the code to find GCD by foll. method..
gcd(a_in,b_in,a_out,b_out)
{ if((b_in==0)||(b_in==1))
{ a_out = a_in;
b_out = b_in;
}
else
{ gcd(a_in,ain%b_in);//recursive function
}
}
This is the logic in C.....but in Verilog i dont know how to repeadtedly call the module modulus which fins a_in % b_in..
Below is my Verilog code,plese tell me where i'm wrong...
I want the code to find GCD by foll. method..
gcd(a_in,b_in,a_out,b_out)
{ if((b_in==0)||(b_in==1))
{ a_out = a_in;
b_out = b_in;
}
else
{ gcd(a_in,ain%b_in);//recursive function
}
}
This is the logic in C.....but in Verilog i dont know how to repeadtedly call the module modulus which fins a_in % b_in..
Below is my Verilog code,plese tell me where i'm wrong...
Code:
module gcd(clk, start, a_in, b_in, a_out, b_out, done);
input clk;
input start;
input [31:0] a_in;
input [31:0] b_in;
output reg [31:0] a_out = 0;
output reg [31:0] b_out = 0;
output reg done = 0;
reg [3:0] cnt = 0;
reg rst_in = 0;
reg rst_start;
integer a,b;
wire [31:0] result;
wire recv = 0;
always@(posedge clk) begin
if(start)begin
a <= a_in;
b <= b_in;
cnt = 1;
end
else if(b==0 || b==1) begin
a_out <= a;
b_out <= b;
done <= 1'b1;
cnt = 2;
end
else if(cnt == 1)begin
rst_in<= 1;
cnt = 2;
end
else if(recv == 1)begin
a <= b;
b <= mod_gcd.result;
a_out <= 1;
rst_in <= 0;
cnt = 1;
end
end
modulus mod_gcd(clk,start,rst_in,a,b,result,recv);
endmodule
Code:
module modulus(clk,start,rst,x,y,result,done);
input clk;
input start;
input rst;
input [31:0] x;
input [31:0] y;
output reg [31:0] result;
output reg done = 0;
integer rem,y1 ;
always @ (posedge clk) begin
if(start) begin
rem <= x;
y1 <= y;
result <= rem;
end
else if(rst) begin
if(rem < y)
result <= rem;
else
rem <= rem - y1;
done <= (rem < y);
end
end
endmodule
