Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Problem with VCO output (as there is no buffer)

Status
Not open for further replies.
M

mohamedabouzied

Member level 3
Member level 3
Joined
Feb 19, 2006
Messages
60
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,288
Activity points
1,721
i have a VCO working at 2.4 GHz
i should match its output for maximum power transfer
i measured its output impedence, and i put a matching load Zload = Zout*
but when i did that, no output from VCO and the oscillation is dead.

why does this happened?


mohamedabouzied
 

Re: about vco output??

I think you have to match the VCO after buffer with capacitive input. Because the load has big influence on VCO feedback as consequence on VCO oscillation.
 
Re: about vco output??

u mean to use a buffer between the VCO and and outer world?
that buffer is an RF buffer so, it is hard to implement.
also, should i match between the VCO and the buffer?

do u have a good paper or toturial to implement this buffer?


and does that buffer have an inductor?
another bad thing???????


thanx for replay

mohamedabouzied
 

Re: about vco output??

but there is 2 coils
is that ok?
i mean a coil is a big block, is there a way to overcome or replace it?


thanx alot for your replay
mohamedavouzied
 

Re: about vco output??

It depends on your specification... If you have enough area - use inductors, if not - use resistors. Try both to find best suited...
 
about vco output??

the buffer can be done , without coils , it can be comon source amplifer , or common drain , then u can make this drive , the output world

never match the Zof the VCO . alos the Z of the VCO change , coz the VCO is hard nonlinear circuit

khouly
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top