Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

What does the term dummy load mean?

Status
Not open for further replies.
S

smiles

Advanced Member level 4
Full Member level 1
Joined
Jul 27, 2007
Messages
110
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,296
Activity points
2,096
Could you explain me about this term, when people use it and what for ?
Thanks so much !
 

Dummy load

Well it depends on where it has been used. For example an instrument for calibration, testing may temporarily connect output to a dummy load and after calibration, testing,... disconnect it.
In switching power supplies also to reduce noise when current is low, the device may parallel a dummy load and when actual load current becomes more than a certain amount the dummy load will be disconnected.
 

    S

    smiles

    Points: 2
    Helpful Answer Positive Rating
Re: Dummy load

Hi,

It could mean lots of different things.

It could be a resistor or more complex circuit which is used to simulate a load for testing an electrical circuit. (An e-load for example). It could be a resistor which is connected to the output of some IC which needs to source some current to operate correctly or output some voltage. Sometimes it could be used to connect some floating outputs to ground, in case you wanted take open circuit voltage measurements from that output. It could also be used for testing audio amplifier circuits without producing intense sound. Their application in SMPS's are already told here.

Regards.
 

    S

    smiles

    Points: 2
    Helpful Answer Positive Rating
Re: Dummy load

In switching power supplies also to reduce noise when current is low, the device may parallel a dummy load and when actual load current becomes more than a certain amount the dummy load will be disconnected.
Click to expand...
But what for if the last circuit doesn't need its appearance ? Does it help to choose the right device or right compents ?
And where do you think that you must need dummy load for test ?
Thanks !!!
 

Re: Dummy load

An example from RF: Imagine you have a transmitter, an antenna and a cable to connect them both.

Transmitter ---------cable--------- Antenna

If you now switch on the transmitter and disconnect the antenna, all the power will be reflected at the end of the cable and will go back into your transmitter - and will probably blow it up (just to say it in easy words, it's RF theory).

So if you're going to test something with your transmitter without an antenna connected, you need a dummy load at the end of the cable to dissipate the power. The Impedance of the dummy load usually is the same as the characteristic impedance of the transmission line, this prevents high magnitude reflections back into the transmitter.
 

    S

    smiles

    Points: 2
    Helpful Answer Positive Rating
Re: Dummy load

Well thanks so much :)
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top