vahidkh6222
Full Member level 2
I'm trying the serial programming of AD9957 (1 GSPS Quadrature Digital Upconverter). it has a simple 2 wire serial interface with protocol shown in attached picture.
for writing to a register the first bit of instruction byte should be 0 and for reading from the same register we should place 1 at that posuition.
i can successfuly read the default values(then I'm sure with the electrical configuration.... ) but i can not write to these places.
any suggestions? any experiences with other similar ICs?! please help,
thanks in advance.
for writing to a register the first bit of instruction byte should be 0 and for reading from the same register we should place 1 at that posuition.
i can successfuly read the default values(then I'm sure with the electrical configuration.... ) but i can not write to these places.
any suggestions? any experiences with other similar ICs?! please help,
thanks in advance.