Problem with fuse settings of a circuit for PIC16f877

Here is the simple circuit for PIC16f877A that I design , I check the hardware very carefully but when I embed my charged PIC into the circuit, just to test output high and low, it not work ??? I also wonder why the crystal measured by oscillatior has no signal, try to replace another crystal but still the same, do you think that I have to check software also ???
MCLR pin is ok (5V, press button to reset then 0V)
I use CCS compiler, here is .h file

#include <16F877A.h>
#device adc=8

#FUSES NOWDT //No Watch Dog Timer
#FUSES RC //Resistor/Capacitor Osc with CLKOUT
#FUSES PUT //Power Up Timer
#FUSES NOPROTECT //Code not protected from reading
#FUSES NODEBUG //No Debug mode for ICD
#FUSES BROWNOUT //Reset when brownout detected
#FUSES NOLVP //No low voltage prgming, B3(PIC16) or B5(PIC18) used for I/O
#FUSES NOCPD //No EE protection
#FUSES NOWRT //Program memory not write protected

#use delay(clock=4000000)
#use rs232(baud=9600,parity=N,xmit=PIN_C6,rcv=PIN_C7,bits=8)

Hope you help me, thanks so much

#fuses pic16f877a

Where is crystal setting?
It is external RC oscillator by me!

pic16f877a rc oscillator

Hi!
Your fuse setting is probably wrong.
#FUSES RC //Resistor/Capacitor Osc with CLKOUT.
it should be
#FUSES XT //External crystal oscillator
Regards.

pic16f877 rc oscillator example

Thanks !!!
I will try it

I want to know how to add #fuse libraries in MPLAB. Pls Help

I think it depends which compiler you are using. For example in C18 you just write #pragma config, for example: #pragma config FOSC = INTOSC_HS. You can set then outside code in mplab, you have to go in "configure", then "Configuration Bits".