Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

boortstrapped switch work with 1source 1.8v

Status
Not open for further replies.
W

wael_wael

Full Member level 4
Full Member level 4
Joined
Dec 3, 2005
Messages
221
Helped
5
Reputation
10
Reaction score
2
Trophy points
1,298
Activity points
2,760
Dear friends

i am looking to design bootstrapped switch for T&H i.8v, i need some we was design it guide me to finish design the switch(at least give me some guide lines), i have find many papers but in fact the result of my work is not good and the sizes were big, more than 100/0.18u, and the capacitors more than 6 pF(same the below).
thanx in advanced
 

Hi,
The paper by Dessouky in JSSC 2001, these two papers:

And the Abo thesis (Berkeley, 1999) are useful materials.
 

    W

    wael_wael

    Points: 2
    Helpful Answer Positive Rating
Thank you very much.
The papers are very useful.


Best regards!
 

thank u so much, but Dessouky in JSSC 2001 has to sources Vdd, Vss. so i tried to design it with one source but i got no success, any way also the circuit above has problem the size of capacitors so big more than 6 pF and still diffecult for me to get 2vdd in N1,
best regards i will see abo thesis,
regards
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top