Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
what software are you using? if you use altium designer, after routing finished, place polygon(s) then you can change prefered clearance to whatever you want and rebuild your polygon(s).
1.Design
2.Rules....
3.PCB Rules and Constraints Editor
4.Design Rules
5.Electrical
6.Clearance
7.click Right
8.New Clearance
9.You Can Control
9.1Full Quency
InPolygon
9.2Full Quency
IsTrack and IsPad and IsVia
9.3Different Nets Only
30 mil or 50 mil or 10 mil
10.you can select many size Clearance.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
