Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
In CML driver, the load is 50ohm at each branch. So, resistor is the best choice for the impedance matching, but when it comes to noise effect, resistor does contribute to higher noise as the value is only 50ohm, noise= 4kT/R.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
