Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

minimum grid in the layout?

Status
Not open for further replies.

JackyH

Newbie level 6
Newbie level 6
Joined
Aug 29, 2007
Messages
13
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,399
cadence snap to grid off

Hi,

In the layout, the X snap spacing and Y snap spacing can be setted.

I had setted these spacings as 0.005 when I drawed the layout, but afterwards, I found there seems to be a minimum gird setting defined by the technology. This minimum grid is probably 0.05 um in the technology.

SO are there any problems if my spacings settings is too small, will it influence the chip fabrication?

thanks a lot!
 

skill and offgrid

You can't go below the manufacturing grid. If you go smaller the the Mgrid round off errors to the nearest Mgrid will occur during mask writing.
 

    JackyH

    Points: 2
    Helpful Answer Positive Rating
off grid error skill round

hii

no you cant go bryond grid setting

there are some skill coding in which you can set all the things in to new grid

ttry for that

Regards

An@layouT
 

    JackyH

    Points: 2
    Helpful Answer Positive Rating
yes there is. if your'e using a tool that has a snap to grid function. it helps. just make sure that your'e using a process that also uses 1 type of grid.
 

    JackyH

    Points: 2
    Helpful Answer Positive Rating
how can I find the snap to grid function in cadence layout window?
 

hi,

first never go beyond the minimum precision. this will give you OFF GRID errors. believe me this is the WORST DRC error. you have to do your layout again at most if you encounter this error. if a spacing requires 0.15 um put your accuracy to 0.1, then just go for 0.2 um spacing. well if you really want to save space, then you can go down to 0.01 accuracy but i don't think it will really give you a lot of saved space especially when your layout is just a small one.

are you using virtuoso? you can go the options menu then click the display pull down menu. you can see the x and y snap spacing.

hope this helps.

- al :)
 

    JackyH

    Points: 2
    Helpful Answer Positive Rating
The minimum grid is specified by the foundry.
During fabrication, the fabrication tip moves only on the grid. so all the off-grid points will not be formed properly. In some cases the artifacts or some other minor shapes can be waived for off-grid. devices should not be offgrid.
 

    JackyH

    Points: 2
    Helpful Answer Positive Rating
From my own experience, after my DRC execution many offgrid errors appeared on the drc report. I think they will not fabricate a layout w/ drc errors unless those are proven psuedo errors.
 

    JackyH

    Points: 2
    Helpful Answer Positive Rating
you are right .Offgrid errors must be fixed.
 

    JackyH

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top