Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

cadence simulation question

Status
Not open for further replies.
J

Julian18

Full Member level 3
Full Member level 3
Joined
Apr 9, 2007
Messages
167
Helped
5
Reputation
10
Reaction score
5
Trophy points
1,298
Activity points
2,389
lastschematicextraction sylastextraction

Hi, there
A cadence simulation question: I change the library from one path to another, then I can not simualtion but get the following error msg:
"None of the properties 'lastSchematicExtraction' or 'syLastExtraction' was found"

how to overcome it?

thanks
 

lastschematicextraction

urgent! need help
 

none of the properties lastschematicextraction

I think you used a wrong library
 

no, library is correct, i guess maybe the local time of the two machines between which i copied from each other is not the same.

any ideas?
 

The use of the term extracted is not a good one. The schematic editor will do an
"extract" when it checks and saves. The datestamp set by check and save is compared to the last modified datestamp in the editor. If modification is after extraction you get that message.

That message can be even odder and more confusing when netlisting an
extracted view. Since the extracted view is structurally the same as a
schematic view, just without the interconnect lines being drawn, the same
netlisting code is used. If you manually edit the extracted view, the
lastSchematicExtraction property needs to be set. I don't recall how you
keep the last modified time from being changed by the setting of the
lastSchematicExtraction.

Hope this helps you
 

    J

    Julian18

    Points: 2
    Helpful Answer Positive Rating
Thanks Dunn,
But I still want to know how to get rid of this,
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top