Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

is Post Layout Simulation necessary for 0.35 process analog

Status
Not open for further replies.
H

huangjw

Member level 2
Member level 2
Joined
May 10, 2005
Messages
53
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Visit site
Activity points
1,694
hi, all:
for 0.35 mixed-signal process, is it necessary to do post layout simulation.
thanks!
 

functional check is needed.
and if your circuit working freq is much more than 10Meg. you'd better do postsim for RC-extraction netlist.
 

    H

    huangjw

    Points: 2
    Helpful Answer Positive Rating
Re: is Post Layout Simulation necessary for 0.35 process ana

hi

There isn't any force on you to do the post simulation. this depends on you if you want to get the more precise results.

regards
 

it depend on the circuit.

if it's just a bias circuit, the post layout simulation is of no use .
 

Agree!
because your rc-extraction netlist pricision is decided by yourself, so you can decide if the postsim is in needed.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top