Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

overdrive voltage for CMOS

Status
Not open for further replies.

rampat

Member level 4
Member level 4
Joined
Jun 27, 2007
Messages
69
Helped
4
Reputation
8
Reaction score
1
Trophy points
1,288
Location
bangalore
Activity points
1,756
overdrive voltage cmos

How to calculate the worst case overdrive voltage(Vov) across corners for MOS in CMOS technology.And also since the bias voltage varies,how to take care of this variation while considering the overdrive..
 

cmos over drive voltage

I think the best thing to do is to ask the simulator to calculate it for you. use Hspice
 

overdrive voltage in cmos

Does it mean that we to consider always worst case values for the design?
 

mos overdrive voltage vdsat

it's designer's job to assume the overdrive voltages. and see in the output listing file about the min required vdsat so that u can check whether u r in the safe region.
always consider 0.2-0.4V above the threshold voltage which keeps ur transistor in saturation.
Leave all the junk work & necessary chore to simulator as Sadegh suggested. Analyse the results and change the values if necessary.
Consider values just above the worst case values
 

since overdrive voltage is directly proportional to current, the worst case corner for vdsat depends on the biasing current which biases that particular transistor. since VTH is maximum at slow process corner, vdsat is minimumfor a given current. see where the bias current gives min current at max or min operating temperature depending on whether bias circuit is a PTAT or NTAT or bandgap current. based on above, we can guess at which corner, vdsat will be min or max.
we have tobe careful where vdsat is max since we have tocheck whether all transistors are in saturation only at this corner.
 
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top