Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Normally, I would agree with the o-scope method.
Today, ultralow jitter measurements are more acuarately measured using a spec analyzer. Close in phase noise contributes the most jitter.
First thing you should do is determine what type of jitter you want to measure... (Cycle-to-cycle, edge-to-edge, etc...) Setup for measuring is different for each type. Also, do you know if your 1ps jitter spec, is rms or peak-to-peak?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
