Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

offset and lineatiry in the differential opm with cmfb

Status
Not open for further replies.
S

shanmei

Advanced Member level 1
Advanced Member level 1
Joined
Jul 26, 2006
Messages
430
Helped
8
Reputation
16
Reaction score
8
Trophy points
1,298
Location
USA
Visit site
Activity points
4,496
I design a fully differential opm with cmfb. when the offset is good, the linearity is bad; when the linearity is good, the offset is bad.
How can statisfy both linearity and offset.
Please thanks
 

how did you test offset of the opamp?

it's just from mismatch, it can be shown from simulation?
 

    S

    shanmei

    Points: 2
    Helpful Answer Positive Rating
iamxo said:
how did you test offset of the opamp?

it's just from mismatch, it can be shown from simulation?
Click to expand...


My supply voltage is 5v, I set the Vcm=2.5v(from a refrence coltage) which I want to make the output voltage=2.5, here offset means: if the output voltage=2.47v, so the offset=Vcm-output voltage(in the DC condition)=2.5-2.47=0.03v.

when the linearity is good, the output may not axactly equal to=2.5v
 

the opamp is differential, so the output voltage is just the common mode voltage of output. it's not the offset.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top