Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Rising Edge Detection of digital signal

Status
Not open for further replies.
M

maz_yp

Newbie level 5
Newbie level 5
Joined
Jul 3, 2007
Messages
8
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,334
rising edge detector

Hi
I have three digital inputs (0-5V) and i want to detect the rising edge of each signal and determine which one was set logic high (5V) last

Unfortunately i cannot use a simple processor and I must use logic gates, flip flops, etc

I cant figure out quite how to do this and would appreciate any suggestions :)

Best Regards
Maz
 

rising edge detection

maz_yp said:
Unfortunately i cannot use a simple processor and I must use logic gates, flip flops, etc
Click to expand...

Why not? It would be easier to do this with software. Is this an assignment requirement?
 
detect rising edge

Yes i agree software would be easier, but i have just started doing a 3 month internship at an electronics company and I was asked to develop this circuit.

They cannot use reporgrammable logic devices (somehting to do with insurance and approvals)
 

rising edge detector circuit

This is simple edge detection circuit.

29_1183475380.jpg


The invertor on output is connected to aynchronous clear input, so you will get a short impulse on output as input signal goes high... It will look something like this:
64_1183475618.jpg


So you need 3 Dff and 3 iinverters.
 
edge detection circuit

Thanks for the advice but the difficulty in this matter is that I need to determine which of the three signals was set high last?
.......... ____________
in1___|
..............____________
in2_____|
.....................____________
in3_______|

Thus i need a means of knowing input 3 was set high last?
 

electronic edge detector with simple logic gate

Does signals when they rise stay high?
 

rising edge detection in dsp

I actually considered this and thought of using an integrator but the signal does not necessarily stay high.
 

rise edge detector

I think this circuit will help you.

it is very easy to understand.

there are rc filters to detect a rising edge for each input, and the sr flip-flop remembers which input was last pressed. there are 3 outputs, each one indicates which was last pressed.
 

raising edge digital signal

You can use something like this:


STOP can be generated with edge detectors from my previous post.
 

signal detect edge

Thanks alot guys. rc filters and the sr flip flops are relevent to what I need.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top