Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

What are the back drilled vias?

Status
Not open for further replies.
A

Anonymous_Ricky

Advanced Member level 2
Advanced Member level 2
Joined
Dec 26, 2006
Messages
516
Helped
88
Reputation
178
Reaction score
58
Trophy points
1,308
Location
India
Visit site
Activity points
3,974
hi all,

what are Back Drilled vias and what are the advantages/disadvantages of the same?

thanks & regards,

Ricky
 

Re: Back drilled vias

A back-drilled via is a normal through-hole via in a PCB that connects two signal layers, but the dangling stub hanging down from the last signal layer to the bottom of the board has literally been drilled out. A drill bit with a diameter a few mils larger than the drilled and plated hole drills a "blind" via to within a few mils of the lowest signal layer. This removes the copper stub and prevents a potentially disastrous resonance in the 5 to 10 GHz range. All high-performance backplanes use back-drilled vias.
 
Re: Back drilled vias

It is essentially a more cost effective way of creating a blind via.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top