Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

operating 2.5v devices at 1v supply ??

Status
Not open for further replies.
A

amic

Member level 5
Member level 5
Joined
Aug 30, 2005
Messages
91
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
2,069
Hi,

Would it be possible to use 2.5v mos I/O devices or 3.3v devices using 1V supply ??

Thanks.
 

amic said:
Hi,

Would it be possible to use 2.5v mos I/O devices or 3.3v devices using 1V supply ??

Thanks.
Click to expand...

There is no problem, except that the higher voltage devices have higher threshold voltages and so it's harder to design at 1V supply
 

    A

    amic

    Points: 2
    Helpful Answer Positive Rating
THANKS MSSN

How about 1v vertical pnp device or 1v mos devices? how much maximum supply these devices are supposed to handle safely ? Can I operate them with any supply ( say 2.5V or 3.3V) ?

Thanks in advance.
 

amic said:
THANKS MSSN

How about 1v vertical pnp device or 1v mos devices? how much maximum supply these devices are supposed to handle safely ? Can I operate them with any supply ( say 2.5V or 3.3V) ?

Thanks in advance.
Click to expand...

It depends on whether it is transient or u apply this supply for a long time, anyway, u should contact the foundry and ask them about the maximum supply and its effect on the devices reliability.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top