Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

LO Leakage to RF in mixer [hlp]

Status
Not open for further replies.

No one

Full Member level 5
Full Member level 5
Joined
May 11, 2005
Messages
287
Helped
4
Reputation
8
Reaction score
2
Trophy points
1,298
Activity points
3,425
Hello Everyone;
In a design, I have used a mixer; but the LO leakage to IF section is considerable. How I can attenuate it?
 

what is the circuit topology of ur mixer is it Gilbert cell , or what , specify it and then e can check

khouly
 

You can use a diplexer which separates frequencies but provides Zo termination for all components.
 

    No one

    Points: 2
    Helpful Answer Positive Rating
Balanced or double balanced is better or if there is space ....filters
 

Did you use Gilbert cell for your mixer? And, what is the frequecy of your IF
and LO, if they operate in far distance on spectrum, use a simple RC low pass
filter to filter it out. (Of course, high pass filter can help if IF is higher than LO)
 

    No one

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top