Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Need some information

Status
Not open for further replies.
3

3asal

Newbie level 4
Newbie level 4
Joined
Mar 4, 2007
Messages
5
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,304
Hi all:

I need some information about a QAM Tx Rx system with a suitable channel,
for my primary project , and Ineed a help to write the report of the project ,(what is suitable to start with ?)

thanx
 

Hi,
It is typical when writing a report to keep to a basic outline. In most cases this is something along the following lines.

Abstract/Executive Summary -> Give a short synopsys of the entire project (max 1p)
Introduction
Literature Study
Prelim Design
Detailed Design
Results / Experimental Obsevations
Conclusion and Reccomendations
References
Appendix Contents Page
Appendix A
Appendix B

This is a basic outline and it is possible that is can be shortened if required. If for instance you only perfor an experiment the design chapters would become something like "Experimental setup" and "Experimental procedures"

I hoped this helped. You may also consult a book by BEER "Creative writing as an Engineer" it is very good.

Cheers
Slayer
 

    3

    3asal

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top