Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Command in Hspice to see in which region the transistor is working

Status
Not open for further replies.
S

suhas_shiv

Full Member level 2
Full Member level 2
Joined
Nov 30, 2005
Messages
136
Helped
11
Reputation
22
Reaction score
4
Trophy points
1,298
Activity points
2,461
Hi all,
Is there any command in Hspice to see in which region the transistor is working?

Thanks
 

HSpice Help needed

Hi
In recent hspice versions .op shows the region of transistors.
regards
 

HSpice Help needed

hspice demo.sp > demo.lis

Above is the hspice command to output lis file.
In demo file, add the line .op <time> where time is the time you want to check the operating point.
From lis file, check operating point and there u will see all the parameters for transistors in your netlist and you can observe the operation region
 

HSpice Help needed

.op will tell you,
but only dc, not trans, do you need monitor the work region in trans?
 
HSpice Help needed

EDSPICE of EDWInXP can also simulate the analog and digital designs
 

HSpice Help needed

i dont think there is any such provision in older version of HSPICE but might be there in newer ones...
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top